AHA-2740W/2742W/2744W User's Guide
Like all EISA I/O cards, the AHA-2740W/2742W/2744W does not
have jumpers to change various EISA configuration options. These
options are changed via the EISA configuration utility provided
with every EISA system; however, the AHA-2742W and
AHA-2744W do have a single jumper (J1) that is used to enable or
disable the onboard floppy controller.
Features
Fast Data Transfer Rates
16-bit Wide SCSI data transfer
Up to 33 MBytes/sec burst on EISA bus enabled by large
256-byte FIFO
4.0 MBytes/sec asynchronous Wide SCSI data rate
10.0 MBytes/sec synchronous Wide SCSI data rate
20.0 MBytes/sec synchronous Fast/Wide SCSI data rate
Maximum Off-loading the Host CPU
Onboard sequencer (SCSI PhaseEngine) automates all SCSI
protocol
Low SCSI processing overhead
Bus Master DMA implementation
Task scheduling and message-based communication
Programmable interrupts
32-, 16-, and 8-bit host bus data transfer
Fully Disk Array Capable
Able to boot from any drive on the SCSI bus
Background processing permits smooth error recovery
Extensive support from leading disk array vendors
Advanced Fast SCSI-2/SCSI-3 Implementation
Concurrent support of both 8-bit SCSI-2 and 16-bit SCSI-3 devices
1-4
A
AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
A A
AHA-2740W/2742W/2744W User's Guide
A A
A A
Stock Number: 510647-00, Rev. A
A
A A
Print Spec Number: 492897-00
A A
Current Date: 8/3/94
A A
AAAA AAAA
AAAA AAAA
AAAA AAAA
AAAA AAAA
AAAA AAAA
AAAA
ECN Date: 8/9/94
AAAA AAAA
AAAA AAAA
AAAA AAAA
AAAA AAAA
AAAA AAAA
AAAA AAAA
AAAA AAAA
AAAA AAAA
A
A A
A A
Page: 1-4
A A
A
A A
A A
AAAA AAAA
AAAA A A
A A