Connecting Floppy Drives (Aha-2742W And Aha-2744W Only); Aha-2742W; Pin Floppy Cable To Host Adapter - Adaptec AHA-2740W User Manual

Connecting Floppy Drives (AHA-2742W and AHA-2744W Only)

Floppy disk drives are connected to the host adapter by a 34-pin
floppy ribbon cable with a 34-pin header connector. Up to two
floppy diskette drives can be connected to the host adapter.
Note:
If you are not using the floppy controller on the
AHA-2742W and AHA-2744W, be sure to disable it by
removing the jumper connector on jumper J1.
When connecting your floppy drives, make sure to maintain pin-1
orientation as previously described in Maintaining Pin-1 Orientation
on page 2-18.
Note:
The AHA-2742W and AHA-2744W support only floppy
primary address 3F0h - 3F7h. The IRQ channel is hard-wired for
channel 6 and the DMA channel is hard-wired for channel 2.
To connect floppy diskette drives, follow these steps:
1
Connect one end of the 34-pin floppy ribbon cable to the
floppy connector on the host adapter.
Colored
Stripe
Pin 1
Figure 2-19. 34-pin Floppy Cable to Host Adapter
AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA A
A A
AHA-2740W/2742W/2744W User's Guide
A A
A A Stock Number: 510647-00, Rev. A
A
A A Print Spec Number: 492897-00
A A
Current Date: 8/3/94
AAAA AAAA A A AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
AAAA
Floppy
Connector
Page: 2-25
ECN Date: 8/9/94
AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
Getting Started
Floppy Ribbon
Cable
2-25
A
A A
A A
A A
A
A A
A A
AAAA AAAA AAAA A A A A