Exit Scsi Device Configuration; Exit The Eisa Configuration Utility; Utilities; Scsi Device Configuration - Adaptec AHA-2740W User Manual

AHA-2740W/2742W/2744W User's Guide
Note:
If many drives are set to yes for the SCSI Start Unit
Command, system boot time will vary depending on how
long each drive takes to spin up.

Exit SCSI Device Configuration

When configuration of SCSI devices is complete, press Esc to Exit
SCSI Device Configuration; you will be prompted to either save or
abandon device configurations, as shown in Figure 3-15.
Do you want to SAVE or ABANDON the
current device configuration?
<SAVE=ENTER> or <ABANDON=ESC>
Figure 3-15. Exiting SCSI Device Configuration

Exit the EISA Configuration Utility

Once the host adapter and SCSI devices are properly configured,
save and exit the ECU as instructed on the screen's menu. The fol-
lowing section, Utilities, describes the utilities available in the ECU.

Utilities

Select Utilities from the ECU to access the utilities that are available
with your host adapter, as shown in Figure 3-15.
AIC-7770 Utility Selection Options
( ) Disk Format Utility
<ESC>
Figure 3-16. Utility Selection
3-18
A AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
A A
AHA-2740W/2742W/2744W User's Guide
A A
A A Stock Number: 510647-00, Rev. A
A
A A Print Spec Number: 492897-00
A A
Current Date: 8/3/94
AAAA AAAA A A AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
AAAA
Caution
ECN Date: 8/9/94
AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
A
A A
A A
Page: 3-18 A A
A
A A
A A
AAAA AAAA AAAA A A A A