Before Rebooting Your System; Reassemble The System - Adaptec AHA-2740W User Manual

AHA-2740W/2742W/2744W User's Guide

Before Rebooting Your System

Before rebooting your system and configuring your host adapter,
make sure the following is completed:
1
The SCSI bus is properly terminated.
2
Each SCSI device on the SCSI bus is set to a unique SCSI ID
(0-15 for Wide SCSI devices and the host adapter; 0-7 for stan-
dard 8-bit SCSI devices).
3
The host adapter is firmly seated in the host computer's EISA
slot.
4
8-bit internal SCSI devices are connected to the host adapter
with a 50-pin SCSI ribbon cable and that proper pin-1 orienta-
tion is maintained.
5
16-bit internal Wide SCSI devices are connected to the host
adapter with a 68-pin Wide SCSI ribbon cable.
6
16-bit external Wide SCSI devices are connected to the host
adapter with a 68-pin external Wide SCSI cable.
7
If using the onboard floppy controller on the AHA-2742W and
AHA-2744W, the floppy diskette drive is connected to the host
adapter with the 34-pin SCSI ribbon cable and that proper
pin-1 orientation is maintained.
8
All system and power cables are properly connected.

Reassemble the System

Refer to your system and SCSI device documentation to replace the
system cover and connect all system and SCSI device power cables.
2-28
A AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
A A
AHA-2740W/2742W/2744W User's Guide
A A
A A Stock Number: 510647-00, Rev. A
A
A A Print Spec Number: 492897-00
A A
Current Date: 8/3/94
A A AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
AAAA
ECN Date: 8/9/94
AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
A
A A
A A
Page: 2-28 A A
A
A A
A A
AAAA AAAA AAAA A A A A