Scsi Bus Parity Check; Host Adapter Scsi Id Selection; Scsi Bus Parity Check Selection - Adaptec AHA-2740W User Manual

If two host adapters are installed, each would have its own SCSI bus,
thus each host adapter would still be set to SCSI ID 7. Refer to SCSI
ID Setting on page 2-15 for additional information on SCSI ID.
Wide SCSI Channel Interface Definitions
Host Adapter SCSI ID
[Select=ENTER] [Cancel=ESC]
Figure 3-7. Host Adapter SCSI ID Selection

SCSI Bus Parity Check

Select SCSI Bus Parity Check to enable or disable SCSI bus parity
checking on the host adapter. Figure 3-8 displays your choices. The
default setting is Enabled.
The host adapter always generates parity when writing to the SCSI
bus. If any attached SCSI devices do not support SCSI parity
checking, then SCSI Bus Parity Check should be disabled. Most
devices today, however, do support SCSI parity checking.
Wide SCSI Channel Interface Definition
SCSI Bus Parity Check
[Select=ENTER] [Cancel=ESC]
Figure 3-8. SCSI Bus Parity Check Selection
AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA A
A A
AHA-2740W/2742W/2744W User's Guide
A A
A A Stock Number: 510647-00, Rev. A
A
A A Print Spec Number: 492897-00
A A
Current Date: 8/3/94
A A AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
AAAA
Configuring the Host Adapter
( ) 7
( ) 6
( ) 5
( ) 4
( ) 3
( ) 2
( ) 1
( ) 0
( ) 15
( ) 14
( ) Enabled
( ) Disabled
Page: 3-9
ECN Date: 8/9/94
AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
3-9
A
A A
A A
A A
A
A A
A A
AAAA AAAA AAAA A A A A