The Eisa Configuration Utility; Run The Eisa Configuration Utility - Adaptec AHA-2740W User Manual

3

The EISA Configuration Utility

All EISA machines are shipped with a bootable EISA configuration
diskette that contains a software program generally known as the
EISA Configuration Utility (ECU). This utility is used to automate
the configuration of the motherboard and all option boards installed
in your EISA system.
The ECU must be run every time an adapter card is physically
added, removed, or moved. The ECU operates on the information
provided by the .cfg (configuration) files and . ovl (overlay) files that
accompany the EISA system board and/or adapter card.
Note: Always refer to the documentation provided with your
EISA system for instructions on adding and configuring
adapter boards.
Depending on the ECU supplied with your system, host adapter con-
figuration will vary; however, the basic steps include the following:
Run the ECU.
Copy the configuration and overlay files.
Select the host adapter.
Configure the host adapter parameters.
Configure BIOS and SCSI devices.
Exit the ECU.
Note:
The screens displayed in this chapter may vary from
the screens displayed by the ECU supplied with your system.

Run the EISA Configuration Utility

Run the ECU as instructed by the EISA system vendor.
A AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
A A
AHA-2740W/2742W/2744W User's Guide
A A
A A Stock Number: 510647-00, Rev. A
A
A A Print Spec Number: 492897-00
A A
Current Date: 8/3/94
AAAA AAAA A A AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
AAAA
Configuring the Host Adapter
Page: 3-3
ECN Date: 8/9/94
AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
3-3
A
A A
A A
A A
A
A A
A A
AAAA A A A A