Table of Contents
Advertisement
Available languages
Available languages
Electrical connection :
Powered with a 2,5mm² cross section H07RNF power cable, 2 phases + ground supplied with the equipment.
The terminal shall be connected:
- by a qualified person.
- to an omnipole switch between the terminal and the electric network, in compliance with regulations in effect.
- in series with a high sensitivity differential device with protection against over-currents.
- to an efficient ground, in compliance with regulations in effect.
- to an equipotential conductor, not provided with the equipment, to be connected to the captive nut located low at the
back, between the two grey stops (logo
CONTROL PANEL
1 :
on/off switch
2 :
trolley presence indicator light
3 :
cold temperature displays
4 :
time displays
5 :
manual mode switch
6 :
manual mode indicator light
ADJUSTING THE FEET OF THE TERMINAL
Before adjusting, remove the front protection door, and place it on the side, of the terminal as shown in the diagram (fig 1).
Open the trolley doors and fold them back against the holding magnets on the side of the trolley (fig 2).
- 12 -
).
Fig.1
7 :
timers
8 :
programming switch
9 :
value decrease button
10 :
value increase button
11 :
reheating indicator light
12 :
temperature hold indicator light
Fig.2
Advertisement
Table of Contents
