Gpi/Genlock Rear Panel Connections - Belden Grass Valley KALEIDO-X Installation & Service Manual

Connector label
Head 1
ANALOG OUT 1 L ANALOG OUT 2 L WECO
ANALOG OUT 1 R ANALOG OUT 2 R WECO
AES OUT 1
OPTION 1
Control
The connectors located in the middle of the rear panel are control connectors. The
following table lists the purpose of each control connector.
Connector label
LTC IN 1
LTC IN 2
LTC IN 3
ETHERNET
USB
RS-422

GPI/Genlock Rear Panel Connections

External connections to the GPI/Genlock card are made through connectors mounted on
the KXA-GPI-GEN-R rear panel. These connectors carry both input and output signals.
Head 2
AES OUT 2
OPTION 2
Connector type
BNC
WECO
WECO
RJ-45
USB A
RJ-45 (see note
below)
Note:
The Kaleido-X's RS-422 ports have an RJ-45 connector in order to
preserve space on a busy panel. The RS-422 interface specifies a DE-9
connector, so if you are using this interface, you will require a DE-9-to-RJ-45
adapter. Grass Valley supplies two adapter models, correctly wired for this
application: a straight adapter (part no. 1737-3000-102), and a crossover
adapter (part no. 1792-3700-100). See
page 214 for the RS-422 pinout specification.
Bottom of panel
Connector
type Function
Analog audio output (left channel) to feed
the audio monitoring system
Analog audio output (right channel) to
feed the audio monitoring system
WECO Digital audio output (AES) to feed the audio
monitoring system
RJ-45 For future use
Function
Time code input #1
Time code input #2
Time code input #3
100 Base-T Ethernet connection
Connect a mouse, keyboard, or USB key for Kaleido
Software upgrade or data backup
There are three other USB ports accessible on the front of
the card that serve the same functions.
Connect to an RS-422 (SMPTE ST 207, EBU-3245) or
RS-485 device or network
RS-422 Connection
Top of panel
Kaleido-X (7RU)
Installation & Service Manual
Diagram, on
83