Configuring A Client Pc To Configure An Abt's Network Settings - Belden Grass Valley KALEIDO-X Installation & Service Manual

System Configuration

Configuring a Client PC to Configure an ABT's Network Settings

4 Press the RESET button (located on the right-hand side of the ABT rear panel beside the
ETHERNET/POWER RJ-45 connector) for at least 1 second.
The Audio Bridge Terminal will reboot with the following static network configuration:
Property
DHCP
Static IP address
Subnet mask
Default gateway
5 Using a Web browser on the PC, connect to the ABT using the following address:
10.0.3.190.
The home page of the ABT's built-in Web server is displayed.
6 Click Network Configuration (in the navigation pane).
The Network Configuration page is displayed.
7 Change the ABT's network settings, as necessary, and then click Apply & Reboot.
For more information, refer to the Audio Bridge Terminal Guide to Installation and Operation.
See Related
Configuring a Client PC to Configure an ABT's Network Settings
The client PC that you will use to communicate with the Kaleido-X (via XAdmin and XEdit)
and the Kaleido-X itself must have IP addresses within the same subnet. The following
procedure applies to a typical Windows 10, Windows 8, or Windows 7 system.
To change the IP address of the client PC
1 Press the Windows key on your keyboard, type "control panel" and then press Enter.
2 In the search box, type "adapter", and then, under Network and Sharing Center, click
View network connections.
146
Setting
OFF
10.0.3.190
255.255.0.0
10.0.0.1
Note:
Keep in mind that all ABTs ship with the same default static IP
address. If you are adding more than one ABT to your network and do not
use DHCP, make sure to assign each ABT a different static IP address before
connecting them to the network.
Documentation, on page 15.