Table of Contents
Advertisement
Adaptec RAID Installation Guide
13
If your system contains multiple Adaptec RAID controllers,
repeat Steps
14
Restart the system and then open the Device Manager. It
should now show an Adaptec I
SCSI and RAID Controllers section.
Upgrading Windows 95 to Windows 98/Me (Upgrade Version)
If you are upgrading the system from Windows 95 to
Windows 98/Me in an existing system that already has a
functioning Adaptec RAID controller, no further configuration is
necessary. Perform the Windows upgrade; the functionality of the
Adaptec RAID controller is retained.
If the controller is being added in addition to the upgrade, follow the
procedure in
Installing the Driver in a New Windows 98/Me System on
page
3-12.
Novell NetWare
The Adaptec RAID Installation CD contains device drivers for
NetWare 4.11, 4.2, and 5.x. The following Novell support packs are
the minimum level required before installing Adaptec RAID
controller software and drivers:
After you have installed the drivers, you can use the normal
NetWare procedures for modifying disk partitions, applying hot
fixes, or performing volume maintenance.
3-18
6
through
12
NetWare Revision Level
4.11 or 4.2
5.0
5.1
for each Adaptec RAID controller.
O RAID Host Adapter in the
2
Support Pack
8a
5
1
Advertisement
Table of Contents
