Table of Contents
Advertisement
1 For Agilent 83402C products, perform the following two steps:
W A R N I N G
2 Connect a terminated fiber-optic cable or device to the source's OPTICAL OUTPUT
3 Connect the DC cable, supplied with the source, between the source's rear-
4 Make sure that the BNC short is connect to the rear-panel REMOTE SHUTDOWN
5 Insert the key into the source's front panel.
6 Turn the key to turn the source on.
Connecting a Source
a If you are located outside of the United States or Canada, locate the yellow
sheet of IEC laser classification and laser safety labels supplied with the
source. Labels are provided for most major languages.
b Select the two labels in the desired language, and place them on the source
at the two positions shown in
ready be located at these positions.
Do NOT, under any circumstances, look into the optical output or any
fiber/device attached to the output while the laser is in operation.
connector. This protects the user from exposure to laser radiation. See
Figure 1-3 on page
1-7.
panel DC IN connector and a PROBE POWER jack.
You'll find PROBE POWER jacks on the following products:
• Agilent 8702A/B/D lightwave component analyzer
• Agilent 11899A probe power supply
connector.
The source will not operate without the BNC short connected.
Figure 1-2 on page
1-6. FDA labels should al-
Getting Started
Connecting a Source
1-5
Advertisement
Table of Contents
