Table of Contents
Advertisement
General Information
Operating
Receivers
Figure 2-2. Front and rear panels on a receiver
Front and rear panel features
While the DC IN connector provides a connection to power the receiver, the
DC OUT connector can be used to power to another source or receiver.
The front-panel OPTICAL INPUT connector has a special adapter which allows
you to easily change the front-panel connector to one of many standard inter-
faces.
Refer to "Replaceable Parts" on page 2-5
for a figure which shows each
available connector. For Agilent 83411C/D receivers, use a single-mode 9 µm
optical fiber. For Agilent 83410C and Agilent 83412B receivers, use an
62.5 µm multimode optical fiber.
The AVG POWER connector provides an output voltage that is proportional to
the average optical power into the receiver.
The OVER ILLUMINATION light turns on whenever RF input power is too high.
The POWER ON light turns on when DC power is supplied.
The RF OUT connector provides the output for the demodulation (electrical)
signal. It is an SMA threaded female connector.
2-4
Advertisement
Table of Contents
