Agilent Technologies OmniBER OTN Series Installation Manual page 39

Installation.book Page 36 Monday, January 12, 2004 1:13 PM
2
Installation (Getting Started)
36
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The power cord supplied with each instrument varies with the
country of destination. The following figure illustrates the
standard power plug and cord configurations that are
commonly used. The part number shown beneath each plug is
the part number of the appropriate power cord and plug. If the
appropriate power cord is not included with the instrument
notify the nearest Agilent office and a replacement will be
provided.
Figure 2 Power cable configurations and part numbers
Removing the Instrument Covers
The instrument covers are a press-fit. To remove them, gently
lever them off.
When transporting the instrument, always replace both covers
to protect the instrument connectors and display.
Useful Information When Requesting Support
When contacting Agilent Technologies for support it is useful to
have the following instrument information available:
• Model Number.
• Serial Number. (on instrument base plate in the format
GBXXXXXXXXX)
• Instrument Options. (Press <Menu>, choose System >
Options then press <Select>.)
• Instrument Firmware Revision. (Press <Menu>, choose
System > Options then press <Select>. Select the Software
tab.)
• Self Test fail codes and messages. (Press <Menu>, choose
System > Self Test then press <Select>.)
Installation Manual