Agilent Technologies OmniBER OTN Series Installation Manual page 24

Installation.book Page 21 Monday, January 12, 2004 1:13 PM
CAU TI O N
Installation Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Laser Product Classification
All optical modules are classified as Class I (non-hazardous)
laser product in the USA which complies with the United States
Food and Drug Administration (FDA) Standard 21 CFR Ch.1
1040.10, and are classified as Class 1 (non-hazardous) laser
products in Europe which complies with EN 60825-1 (1994) +
A11 1996 +A2 2001 and elsewhere with IEC 60825-1 (2001-08)
Ed. 1.2.
Connecting or Disconnecting Optical Cables
When connecting or disconnecting, ensure you are grounded or make
contact with the metal surface of the Mainframe with your free hand to
bring you, the module, and the mainframe to the same static potential.
Modules may be susceptible to ESD while the module is installed in
the mainframe. You should read the additional ESD information
provided in this manual before servicing the instrument.
The connectors available depend on the options fitted to your instrument.
NO TE
See the Instrument Tour in the Getting Started section of the Online Help
for more information on connectors.
To avoid hazardous exposure to laser radiation, observe the
following during system operation:
• ALWAYS DEACTIVATE THE LASER BEFORE CONNECTING
OR DISCONNECTING OPTICAL CABLES.
• When connecting or disconnecting optical cables between the
instrument and device-under-test, observe the connection
sequences given below.
Connecting: Connect the optical cable to the input of the
device-under-test before connecting to any of the instrument's
Optical Out connectors. Maximum power levels are printed on
the connector panels adjacent to the port.
1
Introduction
21