System Cable Connections; Power Requirements - Omron Quattro 650H ePLC Quick Setup Manual

NOTE: Check the tightness of the mounting bolts one week after initial installation,
and then recheck every 6 months. For periodic maintenance, refer to the Quattro
User's Guide.

1.5 System Cable Connections

Open the Accessory box and locate the eAIB XSYSTEM cable. Connect the cables and peri-
pherals as shown in the following figure. Parts and steps are covered in the following two
tables. Refer to the System Installation chapter in your Quattro User's Guide for power spe-
cifications and wiring instructions.
Part Cable and Parts List
A eAIB XSYSTEM Cable Assembly
B User E-Stop, Safety Gate
C XUSR Jumper Plug
D Front Panel
E Front Panel Cable
F Front Panel Jumper Plug
G XMCP Jumper Plug
H T20 Bypass Plug
J T20 Adapter Cable
K T20 Pendant (option)
L AC Power Cable (option)
M 24 VDC Power Cable (option)
N 24 VDC, 6 A Power Supply
(option)
P Ethernet Cable - PC -> PLC
(Only while programming PLC)
Q Ethernet Cable - PLC -> switch
R Ethernet Cable - switch ->
SmartVision MX
S Ethernet switch, cable
T Camera and cable

Power Requirements

The power requirements for the SmartVision EX and the Quattro robots are covered in their
respective user guides. For 24 VDC, both can be powered by the same power supply.
1.5 System Cable Connections
Quattro ePLC650/800 Quick Setup Guide, 13588-000 Rev D
Page 8 of 16
Part # Part of:
13323-000
n/a n/a
04736-000 13323-000
90356-10358
10356-10500 90356-10358
10053-000 13323-000
04737-000 13323-000
10048-000 10055-000
10051-003 10055-000
10055-000
04118-000 90565-010
04120-000 90565-010
04536-000 90565-010
n/a n/a
n/a n/a
n/a n/a
n/a n/a
n/a n/a
Notes
standard, eAIB
user-supplied
standard, eAIB
standard
standard
standard, eAIB
standard, eAIB
standard, T20
standard, T20
option
user-supplied
user-supplied
user-supplied
user-supplied
user-supplied
user-supplied
user-supplied
option