Installation - GALLERY Classic Eco Installation Instructions Manual

Installation

Install the stove in accordance with the requirements given below. The gas connection will be to the
rear of the stove therefore it is advisable to prepare the pipe work in advance of installing the stove.
Fix the legs to the stove using the bolts provided. When the stove is in the desired position, if required,
fix the brackets provided to the back feet and level the stove using the levelling screws, then mark the
hearth through the holes, remove the stove, and drill and plug the hearth for securing the stove.
FITTING THE BURNER INTO THE STOVE BODY
Slacken the screw securing the door shown in Fig.1 and open the door. Position the burner tray into
the stove, ensuring that the pilot is located to the rear. There are 4 screws already fitted to the internal
stove body brackets inside the stove. Remove these before positioning the to the internal stove body
and reuse them to secure in place. See Fig.2.
Fig.2 Fitting the burner
Fig.1 Door Screw
FITTING THE THERMAL SWITCH
Fit the thermal switch prior to installing the
stove. Fit the thermal switch to the bracket
positioned at the draft diverter at the rear of
the stove, with the 2 screws provided – see
Fig.3.
IMPORTANT: THE STOVE MUST NOT BE
OPERATED WITHOUT THIS THERMAL
SWITCH CORRECTLY FITTED
Fig.3 Thermal switch bracket
7