GALLERY Classic Eco Installation Instructions Manual page 25

REMOTE CONTROL HANDSET
Gas fire burner status
The remote control handset requires 2 AA size alkaline batteries to be inserted under the battery
compartment cover. The orientation of these is shown moulded into the battery compartment.
• To start the fire, with one hand grasp around the rear and both sides of the button area control.
The green unlock light will illuminate. Note: Keep a grip of the handset to keep it unlocked and to
continue to operate the command buttons
• With the other hand touch and hold a finger on the power button for about 3 seconds. A short beep
and a flash of the unlock light will happen
• When the word "pilot" appears at the bottom left hand corner of the display, immediately release
the power button
• A second flash of the unlock light and a longer beep will also sound at the time to release the
power button
• The fire should be lit within a few seconds
• If power button is held for more than a few seconds after second flash/beep/word pilot appears, the
command is ignored for safety reasons
• Similarly if it is released too soon before the word pilot appears, the command is also ignored.
• With this system, the control has been designed to ensure that only intended ignition of the
fire occurs
• To stop – with handset held to unlock it, press then release power button
Mode- MAN (Manual), Zzz (Snooze), thermostat or timed
Day of the week
Battery condition-
RC handset,
FC fire control
Light sensor for
display(back lit)
To change mode
Press to decrease flame
Fig.4 Remote control handset
Time (12 hour or 24 display)
In range of fire (missing
if not in range or if Fire
Control turned off)
Power on or off
Room Temperature
Handset Unlocked
when illuminated
To change handset
settings
Press to increase flame
25