GALLERY Classic Eco Installation Instructions Manual page 27

SETTING THE TEMPERATURE DISPLAY TO CELSIUS OR FAHRENHEIT.
Press and release the + or - button to toggle between °C and °F. When the display shows the desired
symbol, press and release the SET button to store the setting.
As the main settings above have now been done, press and hold (not releasing straight away) the "SET"
button for a few seconds and this will exit the setup menu. Alternatively you can press and release the
set button several more times until the time of day is displayed on the handset.
The control is now ready for use with the Fire Control.
Note: the legend at the bottom shows the battery condition of both the batteries in the hand set and in
the fire control alternately. RC = Remote control handset and FC = Fire Control.
The control is designed to get the most out of the batteries but when eventually the display shows they
are spent (when the battery legend is an empty area) we recommend you change the batteries in the
handset before they are flat, to avoid having to reprogram the time and date settings again.
PAGING THE HANDSET
If you have misplaced the handset (and it is in range of the fire), you can page it by pressing the +
button only on the Control unit for around 5 seconds. The handset will flash and make a noise to help
you to locate it.
Once you pick up and grasp the handset to unlock it, the control unit will detect this and so the sound
stops. The flashing and sound will last for 60 seconds each time the handset is paged as described. If
not found in 60 seconds, page again and so on.
NOTE: PRESS "+" Button ONLY, NOT + and - Together as you will accidentally break the handset
pairing and have to reset handset to factory state and pair again (see the pairing handset section if this
happens).
HANDSET PAIRING
The handset should be supplied already paired with your fire, however if it becomes necessary to cancel
the pairing and re pair it again do the following steps below. NOTE: A new pairing can be accidentally
started by accidentally pressing the plus and minus buttons together at the same time on the control
unit and held for 5 seconds.
27