GALLERY Classic Eco Installation Instructions Manual page 10

FLUE RESTRICTOR RING
This stove is supplied with a flue restrictor ring. The restrictor ring must not be fitted if the stove is to
be connected to a pre-cast flue or a masonry chimney with a diameter of 100mm/125mm. There may
however be certain circumstances where fitting the restrictor ring causes the fire to fail the spillage
test. In such cases the restrictor ring must be removed. After removal, conduct the spillage test again.
Further investigation as to the chimney's suitability must be conducted by the installer in these
instances.
VENTILATION
This appliance only requires normal adventitious ventilation, however new build properties may need
additional measures due to their air tightness. Reference to BS5871 Part 1 should be sought to ensure
all conditions are met for the UK. For Ireland reference should be made to the current edition of IS 813
"Domestic gas installations" to ensure absolute compliance.
GAS CONNECTION
The gas supply connection is at the right hand side of the stove on the inlet to the gas valve. The stove
will come supplied with an 8mm restrictor elbow with a burner pressure test point incorporated for
ease of connection. This must only be connected to the gas supply pipe connected to the gas valve.
A flexible gas hose of any description is not permitted to be used on this appliance downstream of the
provided restrictor elbow. The gas supply must be purged and any loose debris within the pipe must be
cleared prior to ensure there are no blockages as this can cause damage to the gas valve when lighting.
Connect the gas supply pipe and test for gas tightness.
VERMICULITE DISPERSAL MEDIUM
Place the black vermiculite supplied into the burner tray. Completely fill the burner tray. Care should
be taken not to compress it down and to ensure a level surface to allow for a level base when placing the
logs.
10
RESRICTOR RING
(IF REQUIRED)
Fig.7 Flue connections
FLUE SPIGOT