Battery Replacement; Error Codes - GALLERY Classic Eco Installation Instructions Manual

THERMOSTATIC MODE
Thermostatic mode will allow you to set a desired temperature for the stove to maintain. Once the
temperature is reached the fire will reduce the power to minimum and regulate itself to maintain
the temperature. The timed thermostat can be set before or during manual operation of the fire.
Hold the handset to unlock as described previously and press the mode button as many times as
necessary until the THERMOSTAT symbol is flashing at the top of the display.
Press and release the set button and this will put the control into Thermostat mode.
The Sun, Moon or Frost symbol will on the left hand side of the screen depending on the time of
day and temperature.
Press and release the set button to access the temperature control. You can adjust the temperature
using the + or – buttons.
After adjusting the temperature press set again to enter the setting required (or if left for a few
seconds this time is now stored and used).
If the fire is lit this will then adjust the power settings to reach and maintain the temperature. If
the stove is not lit, Press and hold the ON/OFF button for 3 seconds a short beep and a flash of
the unlock light will happen. When the word "pilot" appears at the bottom left hand corner of
the display, immediately release the power button). The fire will now light and adjust the power
settings to reach and maintain the set temperature.

BATTERY REPLACEMENT

HANDSET
The handset is powered by two alkaline AA size batteries. To change the batteries in the handset,
remove the battery cover on the underside of the handset, unclip the batteries from its connector
put in two new ones in its place. Replace cover.
BURNER
Wait until the fire is cold before attempting to change these batteries which are in the gas valve
underneath the burner behind the lower door and controls cover panel (Fig.1). Remove the battery
cover on the gas valve and remove the used batteries. Insert three new alkaline AA batteries
observing the correct polarity. Replace the battery cover.

ERROR CODES

The control unit is NOT faulty just because its shows an error code. The error code can be read
when a wireless control unit is paired with a wireless enabled remote control. The error code is
there to enable servicing to identify what may be happening to the control unit to cause the fire
not to operate correctly. This is most likely to be environmental or one of the other components
that are connected to the control unit.
29