GALLERY Classic Eco Installation Instructions Manual page 24

STOVE CONTROL UNIT
Indicator light
Decrease flame
INDICATOR LIGHT
• Off - Burner is in standby and ready for start, or already in continuous operation
• Fast flashing - Control unit is busy and will not accept commands
• Medium fast flashing - Control unit is preparing a (re)start of the burner
• Slow flashing - Control unit is detecting an error
• One short flash every 8 seconds - Low battery warning
• Always on - Burner is locked
WHITE POWER ISOLATOR SWITCH
• Left position - Control unit is disconnected from all power supplies and does not consume power
• Right Position - Control unit is powered and ready to operate
DECREASE FLAME BUTTON
• Burner in operation - use this button to reduce the power level
INCREASE FLAME BUTTON
• Burner in operation - use this button to increase the power level
POWER BUTTON
• Burner in operation - Use this button to stop burner operation
• In standby mode - Use this button to start burner operation
• Burner locked - Use this button to unlock the burner and to reset from error state.
• If control unit is preparing to restart - Use this button to stop the restart and disable further
automatic starts
BATTERY BOX
• Insert here 3x AA-type alkaline batteries
24
White power isolator switch (sliding)
Increase flame
Power Button
Battery compartment cover opening lever
Battery compartment cover