GALLERY Classic Eco Installation Instructions Manual page 28

FACTORY RESET OF DISPLAY HANDSET
To reset a handset to factory conditions to enable it to be paired with a control:
• Hold the handset to unlock. Press and hold SET until handset beeps and release the set button.
PROG will be at the top left corner
• Press and release the MODE button until the word SETUP is flashing in the top right corner.
• Press and release SET to enter the SETUP menu
• Press and release the set button around 9 times until you see CA0 on the display
• Press then release the + (or – button) to change the display to CA1 and press and release the
SET button again. The word TESC will appear in the window to show that this handset is now
reset and ready to pair again
PAIRING THE HANDSET TO THE FIRE CONTROL UNIT
With 2 good quality AA alkaline batteries in the handset in the direction shown inside, if the
handset can be paired with a control it will display the word TESC as shown in Fig. 7.
The handset must be within 1 metre (3 feet) of the fire when pairing.
After fitting the batteries and with the power isolator, slide switch on the control unit to the on
position (I). Simultaneously press and hold the – and + buttons on the fire control unit (i.e. not
the handset) until the red indicator light comes on. Then immediately release the buttons and
press the ON/OFF button on the control unit. The handset makes a noise and the display shows
the pattern as shown in Fig. 8.
Hold the handset in one hand so your fingers wrap around the back of the operating buttons
area of the handset. A green unlock light will illuminate when the handset has detected your
hand. The green light must be illuminated in this way for any of the command buttons to accept
commands to operate the fire control.
While the display is as shown, and holding the handset as described, press the SET button with
the other hand to finish off the pairing of the handset to the Fire Control. You can then enter the
setup and set the time of day on the handset as detailed earlier in the instruction manual.
Note: If the display returns to the one shown in Fig. 7 with the word "TESC" shown, then too
much time has passed before pressing "SET" and so the handset has not paired yet. Simply repeat
pairing again.
N.B. Only ever press + and - buttons together when pairing handsets. If done afterwards this will
break the pairing made and a factory reset of the handset will need to be performed. See Factory
Reset of display handset.
28