Table of Contents
Advertisement
Installation
Alternate Inlet Connection
In cases where local codes do not permit the fl ex
connector to be used inside the appliance case,
reconnect the fl ex connector outside of the appliance
case. A cut-out is provided in the appliance case for this
purpose.
1. Remove fl ex connector.
2. Remove fl ared connector.
3. Install new inlet elbow.
OR
3/8" elbow
+ short 3/8"
nipple
Common fi ttings required (not supplied)
Option 1
4. Add fl ared connector to new el-
bow and fi t fl ex connector. Close
the access panel.
Flex connector redirected using one elbow.
3/8" street
elbow(s)
(where al-
lowed)
Use common elbow and fi ttings (not
supplied) to redirect the position of the
fl ex connector. NOTE: the fl ex connector
bend radius must be no smaller than
the size of a golf ball (approx. 1-3/4" or
44 mm).
Top view, left side
Front view,
left side
Gas Supply
Option 2
4. Add another elbow, the fl ared
connector and refi t the fl ex
connector. Direct it towards
the rear of the appliance or
downward.
Close the access panel.
Flex connector redirected using two elbows.
Cut-out
19
Advertisement
Table of Contents
