Securing Wheels To The Support Legs; Installing Caster Wheels To The Support Legs; Mounting The Back Support Legs - Pit Boss CHARLESTON PB1230CC Operating Instructions And Recipes

3. SECURING WHEELS TO THE SUPPORT LEGS

Parts Required:
1 x Right Support Leg / Front (#29)
1 x Right Support Leg / Back (#30)
2 x Wheel (#33)
2 x Wheel Axle Pin (#F)
2 x Wheel Washer (#E)
2 x Wheel Cotter Pin (#G)
Installation:
• Attach each Wheel to each Right Support Leg by inserting the Wheel
Axle Pin through the Wheel, Support Leg hole, Wheel Washer, then
secure using the Wheel Cotter Pin.

4. INSTALLING CASTER WHEELS TO THE SUPPORT LEGS

Parts Required:
1 x Left Support Leg - Front (#27)
1 x Left Support Leg - Back (#28)
2 x Support Leg Trim (x31)
2 x Locking Caster Wheel (#32)
4 x Screw (#D)
Installation:
• Mount a Support Leg Trim to each Left Support Leg using two screws.
• Insert each Locking Caster Wheel into the bottom of each Left Support
Leg by hand-tightening into the hole. Ensure that each Locking Caster
Wheel is inserted completely.

5. MOUNTING THE BACK SUPPORT LEGS

Parts Required:
1 x Left Support Leg - Back (#28)
1 x Right Support Leg - Back (#30)
6 x Screw (#A)
6 x Locking Washer (#C)
6 x Washer (#B)
Installation:
• Mount the Back-Left Support Leg to the Main Barrel using three
screws, locking washers, and washers. Install the Support Leg from the
inside of the Main Barrel through the pre-drilled holes.
• Mount the Back-Right Support Leg to the Main Barrel using three
screws, locking washers, and washers. Install the Support Leg from the
inside of the Main Barrel through the pre-drilled holes.
3
29
30
F
E
G
33
4
27
28
31
D
D
5
28
30
INSIDE VIEW
27
28
32
11