Assembly Preparation; Assembly Instructions; Mounting The Wheels To The Legs; Assembling The Cart - Pit Boss PB1000XL/SC3 Assembly And Operation Manual

Wood pellet grill & smoker
Table of Contents

Advertisement

Available languages

Available languages

Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister pack
after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill before
assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt to
assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Customer Service for parts: Monday
through Sunday, 4am - 8pm PST (EN/FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.

1. MOUNTING THE WHEELS TO THE LEGS

Parts Required:
Support Leg (#11)
4
x
Locking Caster Wheel (#14)
4
x
Installation:
Rotate one of the pre-threaded locking caster wheels into the bottom
of a support leg by hand-tightening it into the hole. Continue to install
the other caster wheels to the remaining support legs.

2. ASSEMBLING THE CART

Parts Required:
1
x
Bottom Shelf (#17)
8
x
Screw (#A)
8
x
Locking Washer (#C)
8
x
Washer (#B)
Installation:
Attach the bottom shelf to one of the four support legs using two washers,
locking washers, and screws. Note illustration for support leg placement.
On a level surface, continue to secure the other support legs to the
bottom shelf.
IMPORTANT: The edge of the bottom shelf with holes should face
forward. The holes are for the cabinet doors installation.

ASSEMBLY PREPARATION

ASSEMBLY INSTRUCTIONS

1
11
2
11-2
11-1
11-3
17
14
11-4
B A
C
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

1000xl/sc310550

Table of Contents