nal von minden Reactif Touch Manual page 60

Press to run a Level 2 test if you set the control number to 2 or 3. (For further
instructi ons on how to set QC test levels, refer to Secti on 7 Analyzer Setup: Lockout: QC
Lockout). The test steps are the same as those for Level 1.
When both QC Tests pass, the "E" at the end of the test number will not be shown and
the test mode will change back to Routi ne.
If you set the control number to 3, the Level 3 test will be run, in which the steps are the
same as those for Level 1.
Reacti f Touch
56
nal von minden GmbH · Manual