nal von minden Reactif Touch Manual page 32

The third two-beep sounds prompt the user to dip the third strip into the specimen. The
analyzer will complete the fi rst test and print the result if the analyzer has been enabled
to print automati cally. At this ti me, the user should dip the third strip into the specimen,
lay the strip on the work bench, and put the second strip onto the test table. 15 seconds
aft er the third two-beep sounds, the analyzer will start to run the test with the second
test strip.
Cauti on: It is important to lay the strip on a fl at surface for about 30 seconds. Do not
put the strip on the test table immediately aft er dipping since it may cause
false results.
Note: If the analyzer has been set up to fl ag a microscopy test for one or more para-
meters (refer to Secti on 7 Analyzer Setup: Test Setti ngs: Abnormal Setti ngs:
Flags for Microscopy), the results meet the Microscopy setti ng value (Refer
to Secti on 7 Analyzer Setup: Test Setti ngs: Abnormal Setti ngs: Microscopy
setti ngs) is also displayed on a Microscopy Report screen.
Reacti f Touch
28
nal von minden GmbH · Manual