Table of Contents
Advertisement
Notes on the module
The OPEN/CLOSE
button. does not activate when the power
is turned off. Never push or pull the module forcibly.
Do not push down on the module.
Do not stop the module when it is moving.
Be careful
that
no foreign object
is caught
between
the
module and the cabinet.
lf the foreign object should be caught in this position, press
the OPEN/CLOSE button immediately so that the module will
move to the opposit direction.
If you leave the foreign object between the module and the
cabinet for 10 seconds, the module will automatically move
to the opposite direction.
Eseeneneneet
|
PS-FL1 /FL1C
PS-FL1/FL1C
@Carefully
place the platter on the motor
board
by fitting the
center hole over the center spindle. Be careful that no foreign ob-
jects lodge under the platter.
@ Place the rubber mat on the platter, aligning the holes in the rub-
ber mat and the holes in the platter.
Platter
Match the
projection
with the hole.
Align the holes in the
rubber mat with the
holes in the platter.
CARTRIDGE INSTALLATION
Notice on the PS-FL1C
The supplied cartridge has been instailed on the cartridge shell
at the factory. The following procedure is not necessary unless
you replace the cartirdge.
Any cartridge weighing from 2.5 to 7 grams can be mounted onto
the supplied cartridge shell.
@ Connect the lead wires of the shell to the corresponding pins on
the cartridge.
Wires
Cartridge pins
White...........
White, L (Left channel signal)
Blue
82-2
eae
deed Blue, LE or G (Left channel ground)
Reds. beak
ee ee
Red, R (Right channel signal)
Green
ea
A
sk ae aes Green, RE or G (Right channel ground)
TONEARM ASSEMBLY
@ Secure the tonearm to the arm rest.
@ Plug the cartridge shell into the tonearm and turn the locking col-
lar counterclockwise until the shell is firmly locked.
@ Insert the counterweight and turn it in the direction of the arrow.
@ Temporarily install the cartridge into the shell with the supplied
mounting screws as illustrated.
Cartridge
Parallel
Cartridge shell
SH-151 (supplied)
Stylus tip over this point
Guide pin
Note
The cartirdge supplied with this turntable is unified with the shell.
To use a different cartridge, refer to page 15.
;
Counterweight
Arm rest
Locking collar
Anti-skating compensator
Advertisement
Table of Contents
