Eac 10 Control Panel; Keys And Knobs - ESAB Versotrac EWT 1000 Instruction Manual

5 OPERATION
5.8 EAC 10 control panel
1. Welding stop
2. Welding start
3. Welding current / Wire feed
speed/balance*
4. Arc voltage / Offset voltage*
5. OK / Setting menu
6. Back
7. Manual wire feed upward
*Only with Aristo® 1000 in AC mode.
5.8.1

Keys and knobs

The buttons are used for Up, Down, Right, Left, and
Confirm (middle button) during configuration and
setting.
Welding stop (1). Stops all travel motions, all motors, and welding current.
Welding start (2). The LED is lit when welding is in progress.
The OK button (5) is used to confirm a selection.
The Back button (6) is used to go back one step in the menu.
Press the Manual wire feed upward button (7) to feed the wire upward. The
wire is fed as long as the button is pressed.
Press the Travel motion (8) button to drive in the welding direction of the
symbol indicated on the weld equipment.
0463 613 101
8. Manual travel motion direction
9. Fast motion
10. Manual wire feed downward
11. Manual travel motion direction
12. Memory 1, 2, 3 / Soft keys
13. Travel speed / frequency*
14. USB connection
Left
- 26 -
Up
Right
Down
© ESAB AB 2020