Set Screen, Analog Power Source; Welding Menu - ESAB Versotrac EWT 1000 Instruction Manual

5 OPERATION
5.8.6

Set screen, analog power source

SET
With an AC power source: A short press of the OK button opens the AC
SETTINGS screen.
With an Aristo® 1000 power source and SAW welding head: A short press of the
OK button opens a screen where the knobs will control frequency, balance, and
offset.
Save values and return to the MEASURE screen by pressing the Back button.
5.8.7

Welding menu

When either the SET or MEASURED screen is shown, long press OK to open the
extended WELDING MENU.
The information on the display depends on the authorization level, and the attached power
source and welding head. The authorization level is shown with an icon in the upper-right
corner of the display.
Example welding menu for Aristo® 1000 AC/DC
WELDING MENU
METHOD
REGULATION TYPE
START TYPE
CRATER FILL TIME
BURNBACK TIME
0463 613 101
MEASURED
DC+
CA
DIRECT
0.0 s
0.50 s
- 30 - © ESAB AB 2020