Connecting To A Compatible Dc Analog Power Source - ESAB Versotrac EWT 1000 Instruction Manual

4 INSTALLATION
4.5.2

Connecting to a compatible DC analog power source

Connect the interconnection cable to the connector marked "II".
Interconnection cable between analog-based ESAB power source and EAC 10 control unit
are available as accessories in different lengths.
Always use the dust cover on connections where no cable is connected.
Requirements for analog power sources
• Supply 60 V DC or 42 V AC, 50/60 Hz voltage from the welding power source or by
external means.
• Voltage feedback from negative welding terminal (for welding voltage measurement for
display in pendant).
• Start input to initiate welding, analog input (0–10 V DC) for setting welding parameters
(control signal).
• 1000 A/60 mV shunt output for welding current measurement.
Power source connection socket XP2 pinouts
B, C 42 V AC
E, F 42 V AC return
J Power source negative terminal (U-)
W Power source positive terminal (U+)
0463 613 101 - 19 - © ESAB AB 2020