Ranger DST-64T Installation And Operation Manual page 26

• Weight Placement indicators. Based on the Balancing Mode selected, the weight placement
indicate where the correction weight is to be placed on the Wheel.
⚠
CAUTION
The following drawing shows available weight locations.
• Distance, Width, Diameter Plus and Minus buttons. Used to
change the Distance, Width, and Diameter settings during the Measurements
phase of the balancing session (before you spin the Wheel).
Only needed if you want to enter these values manually on the DST64T and
the DST-642D; otherwise, use the Inner Arm and Outer Arm to have the
Balancer determine these values automatically (DST-64T only).
DST-64T / DST642D Wheel Balancers
If the wrong Balance Mode indicators turn on, stop the Balancer and start again. If
you put the weights on the Wheel in a location other than what the Balancer
expects, the Wheel will not balance correctly.
26
P/N 5900192 — Rev. F — March 2021