Ranger DST-64T Installation And Operation Manual page 25

Using the Display Panel
The Display Panel both displays information about the Wheel being balancing and controls the
Balancer.
The parts of the Display Panel include:
• Balancing Mode indicators. DYN, STA, STA2, ALU, OPT, and HID. When a Balancing Mode
is selected, the appropriate indicator goes on.
Note: OPT is the Optimize Function, which is not a Balancing Mode; it is an optional procedure to
lessen the imbalance in a Wheel that is more than 30 grams / 1 ounce out of balance.
• Inner / Distance Window. During the Measurements phase—
prior to spinning the Wheel—this Window shows the distance from
the edge of the Balancer to the inner edge of the Wheel (measured
by the Inner Arm). During the Balancing phase—after spinning the
Wheel—it shows the weight to be added to the inner edge/plane of
the Wheel.
Width Window. During the Measurements phase, this Window shows the Width of the Wheel.
Determined automatically from the measurements taken by the Inner and Outer Arms (DST-64T
Only). Data is manually entered using the Distance, Width and Diameter buttons on the DST-642D.
• Outer / Diameter Window. During the Measurements phase,
this Window shows the Diameter of the Wheel (measured by the
Outer Arm). During the Balancing phase, it displays the weight to
be added to the outer edge/plane of the Wheel.
DST-64T / DST642D Wheel Balancers
25
P/N 5900192 — Rev. F — March 2021