Ranger DST-64T Installation And Operation Manual page 23

If the Wheel does not spin or spins counterclockwise instead of clockwise, turn the Balancer off
and contact your dealer, visit www.bendpak.com/support/, or call (805) 933-9970.
Put the Outer Arm against the Outer Edge and wait for the beep.
If there is no beep, refer to
Final Checklist Before Operation
Make sure the following has been accomplished
• Review the Installation Checklist to make sure all steps have been performed.
• Check to see that all Anchor Bolts are in position and tightened.
• Leave the Manual with the owner/operator.
DST-64T / DST642D Wheel Balancers
Troubleshooting for more information.
before
23
using your Balancer:
P/N 5900192 — Rev. F — March 2021