Ranger DST-64T Installation And Operation Manual page 18

Switching to the Hood
the Hood Mount Arm. The Handle in the Hood should be at the front of the Balancer.
Replace the two Hex Bolt and Split Lock Washer you just removed; tighten them securely.
Test the Hood to verify it moves back and forth smoothly.
Installing the Outer Arm (3D Quick-Touch™ Data Wand™)
(DST-64T only)
The Outer Arm is used to automatically establish the Diameter of the Wheel being balanced.
To install the Outer Arm:
Locate the Outer Arm Mount Bar, the Outer Arm, and the Hex Bolt required to connect them.
– The Outer Arm Mount Bar connects to the Mount Box using four Hex Bolt, four Split Lock
Washers, and four standard Washers.
– The Outer Arm connects to the Outer Arm Mount Bar using one Hex Bolt, one Split Lock
Washer, and one large black plastic Washer. These are shipped installed on the long piece
connected to the Outer Arm counterweight.
Remove the four Hex Bolt, four Split Lock Washers, and four standard Washers from their location
on the Mount Box.
Connect the Outer Arm Mount Bar to the Mount Box using the four Hex Bolts, Split Lock Washers,
and standard Washers you just removed. Tighten securely, but do not overtighten.
Remove the Hex Bolt, Split Lock Washers, and large black plastic Washer from the end of the Rod
connected to the Outer Arm counterweight.
Slide the Rod through the Tube on the Outer Arm Mount Bar, then reattach the 4 mm Hex Bolt,
Split Lock Washer, and large black plastic Washer you just removed.
DST-64T / DST642D Wheel Balancers
, put the Rod on one corner of the Hood into position next to the top of
18
P/N 5900192 — Rev. F — March 2021