REMOVING THE CONVECTION FAN BLADE AND FAN MOTOR (For the Lower oven only)
1. Remove the burner cover U.(See step 1~4 on page 3-17)
2. To remove the fan blade :
- Remove the nut by screwing clockwise with 5/16 inch wrench. The fan
blade can be replaced from inside oven.
• Be careful not to bend the fan blade
- Doing so can result in vibration, noise, and poor performance of
convection when operating.
COMPONENT ACCESS
Nut
CAUTION
3. To remove the fan motor assembly :
a) Pull the range out of its mounting location so that you can access the
rear of the unit.
b) Remove the screw from the motor cover and then remove motor
cover.
c) Disconnect the wire connection and remove the 3 screws.
Wire connection
3 screws
-3-18-
screw