REMOVING THE CONVECTION FAN BLADE AND FAN MOTOR
1. Remove the burner cover U.(See step 1~4 on
page 3-13)
2. To remove the fan blade :
- Remove the nut by screwing clockwise with
5/16 inch wrench. The fan blade can be
replaced from inside oven.
CAUTION
• Be careful not to bend the fan blade
- Doing so can result in vibration, noise, and poor
performance of convection when operating.
COMPONENT ACCESS
(For the Lower oven only)
Nut
3-14
3. To remove the fan motor assembly :
a) Pull the range out of its mounting location so
that you can access the rear of the unit.
b) Remove the screw from the motor cover and
then remove motor cover.
c) Disconnect the wire connection and remove
the 3 screws.
Wire connection
3 screws
screw