Removing The Broil Burner Assembly(For The Upper Oven Only) - LG LUTG4519SN Service Manual

REMOVING THE BROIL BURNER ASSEMBLY(For the Upper oven only)

• DISCONNECT power supply cord from the outlet
before servicing.
• Replace all panels and parts before operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal injury, death or
electrical shock.
• Make sure the igniter connector is completely
outside when reinstalling the broil burner assembly.
• Use caution when handling sheet metal parts while
servicing the range.
- Some parts may have sharp edges, which could result in injury.
1. Turn off the electrical supply and gas supply going to the range.
2. Remove the upper oven door and remove the racks from inside the oven.
3. Remove the rear back cover, and motor cover : (see step 2,4,5 on page 3-2).
4. Disconnect the igniter plug.
COMPONENT ACCESS
WARNING
CAUTION
4 screws
5. To remove the broil burner assembly:
a) Remove the back cover by removing the screw.
b) Remove the 3 screws in the order for easily removing.
c) Remove 1 screw from the igniter bracket.
d) Remove the igniter connector in the cavity
(To get the connector, pull the wire toward the cavity).
e) Remove the broil burner assembly.
NOTE : When removing the screws, make sure holding the : broil burner
assembly.
6. To remove the igniter:
a) Perform step 1-5 on this page.
b) Remove the 2 screws and then remove the igniter.
-3-15-
Screw + Washer
Screw (2ea) Igniter bracket
Screw (2ea)