Removing The Convection Element, Fan Blade And Fan Motor - LG LDE4415ST Service Manual

REMOvING THE CONvECTION ELEMENT, FAN BLADE AND FAN MOTOR

1. Disconnect power and remove oven racks.
2. Pull the range out of its mounting location so that
you can access the rear of the unit.
3. Remove the control cover. (See step 3 on page 3-2.)
4. Remove the back cover.
(see page 3-8 for the procedure)
5. Disconnect the wire connection.
6. Remove the four Fan cover screws and set the
fan cover aside.
7. Remove the two convection
element screws and pull the
element forward.
COMPONENT ACCESS
(For the Lower oven only)
8. To remove Fan blade, remove nut by screwing
clockwise. fan blade can be replaced from inside
oven.
• Be careful not to bend the fan blade
- Doing so can result in vibration, noise, and
poor performance of convection when
operating.
9. To remove fan motor assembly, disconnect
wire connection and remove the three bracket
screws
10. Pull the fan motor assembly forward.
Convection
heater
Fan cover
Fan cover screws (4ea)
3-15
CAUTION
Screws
Rear-fan
Fan
blade
blade
Washer
Bushing
Washer
Nut
Fan motor