Install The Netlink Oai Gateway; Perform Initial Test - SpectraLink NetLink MOG600 Installation Manual

SpectraLink Corporation

3. Install the NetLink OAI Gateway

Place the NetLink OAI Gateway on a shelf or other predetermined location. The Gateway
is only physically connected to the Ethernet switch and may be placed in any convenient
location.
3.1

Perform Initial Test

1. Connect the power plug from the NetLink OAI Gateway's power adapter to the
power jack on the front (or rear) of the Gateway box.
Use only the adapter ordered from SpectraLink.
2. Plug the power adapter into an outlet or outlet strip.
3. Apply power to the Gateway.
• The error LED should be off.
• LED 1 should be blinking.
New System Installation
If this is a new system installation, place, power up and test the OAI Gateway when the
rest of the system is tested. See the Setup and Maintenance: NetLink Wireless Telephone
document for your system for more information.
Installing in an Existing System
If you are adding OAI to an existing system, the entire system will need to be reset before
the NetLink OAI Gateway can be used. See the Setup and Maintenance: NetLink
Wireless Telephone document for your system for more information.
Part Number: 72-0078-07-A.doc
Installation
NetLink OAI Gateway
Page 13