Installation; Before You Begin; Single Stage Installation - ATEN Master View CS-1754 User Manual

Installation

Before you Begin

1. Make sure that power to all the devices you will be
connecting up have been turned off. You must unplug the
power cords of any computers that have the Keyboard
Power On function. Otherwise, the switch will receive
power from the computer.
2. To prevent damage to your installation make sure that all
devices on the installation are properly grounded.

Single Stage Installation

To set up your CS-1754 / CS-1758 installation, refer to the installation
diagrams on the following pages, and do the following:
1. Plug your USB keyboard, USB mouse, monitor, microphone and
speakers into the Console USB Ports located on the unit's rear panel.
2. Using a KVM cable set (requires a separate purchase, see the
Cables section on p. 3), plug the custom SPDB connector into any
available CPU Port on the switch and plug the accompanying
microphone and speaker cables into the CPU Port's microphone and
speaker jacks.
Note: Be sure that all the plugs are in the same CPU Port sockets
(all in Port 1, all in Port 2, etc.).
3. At the other end of the cable:
a) For a USB connection (see p. 10), plug the USB, video,
microphone and speaker cables into their respective ports on the
computer.
b) For a PS/2 connection (see p. 10), plug the keyboard, mouse, video,
microphone and speaker cables into their respective ports on the
computer.
4. Plug the power adapter cable into the switch's Power Jack, then plug
the power adapter into an AC power source.
5. Repeat steps 2 - 4 for any other computers you are connecting up.
This completes the single stage installation, and you can turn on the
power to the computers.
Note: The CS-1754 / CS-1758 initially links to the first comuter you turn
on.
8 CS-1754 / CS-1758 User Manual