ATEN Master View CS-1754 User Manual page 42

(F4 ADM: continued)
Setting
SET QUICK
VIEW PORTS
SET
ACCESSIBLE
PORTS
FIRMWARE
UPGRADE
PORT OS
36
This function lets the Administrator select which Ports to include as
Quick View ports.
Note: Only the Ports currently chosen for the LIST view on the
main OSD screen (see p. 31), show up here.
w To select/deselect a port as a Quick View Port, use the
Navigation Keys to move the highlight bar to it, then
Press [Enter].
w When a port has been selected as a Quick View Port, an
arrowhead displays in the QV column of the LIST on the Main
Screen to indicate so. When a port is deselected, the
arrowhead disappears.
w If one of the Quick View options is chosen for the LIST view
(see p. 31), only Ports that have been selected here will show
up on the LIST display on the main OSD screen.
w If one of the Quick View options is chosen for Auto Scanning
(see p. 33), only Ports that have been selected here will be Auto
Scanned.
The default is for no ports to be selected.
This function allows the Administrator to define User access to
the computers on the installation on a Port-by-Port basis. For
each User, select the target Port; then press the [Spacebar] to
cycle through the choices: F (Full access), V (View Only) or
blank. Repeat until all access rights have been set, then press
[Esc]. The default is F for all users on all Ports.
Note: A blank setting means that no access rights are granted.
The Port will not show up on the User's LIST on the Main Screen.
In order to upgrade the CS-1754 / CS-1758's firmware (see p.
39), you must first invoke Firmware Upgrade Mode with this
setting.
Specifies the operating platform of the computer attached to each
port. For each port, press the [Spacebar] to cycle through the
choices (PC Compatible, Sun, and Mac). Repeat until all the ports
have been set, then press [Esc]. The default is PC Compatible.
Function
CS-1754 / CS-1758 User Manual