Digital Projection
Titan 800 3D series
Signal Inputs and Outputs
Rear Connection Panel
VGA (input 1)
•
Use
Auto Setup
in the
Input Settings/Picture/VGA Setup
see the Operating Guide.
HDMI (input 2), DVI (input 3)
Analog or Digital DVI-I
•
Set
in the
DVI-I Port
Global Settings/Input Configuration
and
. For more settings, see the Operating Guide.
Analog
Digital
SPDIF
•
Compatible audio sample packets on the HDMI input stream are decoded by the
projector and output on the SPDIF connector. This is a digital output.
3G-SDI (input 4)
•
If two video streams are being transmitted, set
Configuration
menu to choose between the two streams.
CVBS1 (input 5)
•
Connect a Composite Video input signal to the BNC connector.
S-Video (input 6)
•
Connect to the 4-pin mini-DIN connector.
Component (input 7)
RGsB or RGBS
•
Set
Component Colour Space
in the
RGB
.
•
Set
to
Component Sync Type
Auto
between
(RGsB) and
3 Wire
4 Wire
YPbPr
•
Set
in the
Component Colour Space
.
YPbPr
CVBS2 (input 8)
•
Connect a Composite Video input signal to the RCA phono connector.
Rev A June 2012
SIGNAL INPUTS AND OUTPUTS
menu. For more settings,
menu to choose between
in the
3G Level B Stream
Global Settings/Input Configuration
, except when the projector has problems selecting
(RGBS).
Global Settings/Input Configuration
Input
menu to
menu to
Notes
For a complete listing of pin
configurations for all signal and
control connectors, see Wiring
Details later in this Guide.
See the next page for important
information about the differences
between the two connection panels.
Component
DVI
VGA
HDMI
SPDIF
CVBS1
CVBS2
S-Video
3G-SDI
Rear Connection Panel
Connection Guide
Page Conn_1