Table of Contents
Advertisement
WHAT'S INCLUDED
•
2 x 1.2m, 1:1/10:1 probe (conforms with EN 61010-031:2002+A1:2008)
•
Power cable
•
User Manual
•
2 x current-to-voltage converter module
•
Multimeter pen
•
DC adaptor
OPERATING PARAMETERS
•
User-friendly front panel with clear labelling to enable access to all basic functions
for easy operation.
•
Powerful trigger and analysis ability make it easier to capture and analyse
waveforms.
•
Clear LCD and mathematical operating functions make it easy to use to observe
and analyse signal problems in a faster and clearer way.
Model
72-9355
72-9360
72-9365
CONTROLS AND CONNECTIONS
•
The oscilloscope comes with a front panel with at-a-glance functions for easy
operation.
•
There are function keys and a special function jog dial on the front panel.
•
The row of 5 keys at the bottom of the display panel are menu operation keys
(designated as [F1] to [F5] from left to right). With these 5 keys you can set up
different options of the current menu.
•
The other keys are function keys. You can use them to enter different function
menus or access particular functions directly.
•
Apart from the waveform display zone, the
display panel also features other details about
the waveform and the unit's control setup. These
are explained by their sequence numbers in the
above figure:
1.
Trigger source status display is as follows:
A. Select signals of Channel A as the trigger
signal source.
B. Select signals of Channel B as the trigger
signal source.
AB. Select signals of Channels A and B as the
alternate trigger signal source
2.
Trigger coupling mode display is as follows:
~ AC trigger coupling mode, i.e. only AC quantities
larger than 10Hz of the trigger signals can
pass the coupling capacitor. The DC% will be
intercepted. This is a general trigger coupling
mode.
Bandwidth
60MHz
100MHz
200MHz
3
Sampling Rate
250MS/s
500MS/s
1GS/s
Display
Colour
Colour
Colour
Advertisement
Table of Contents
