Pre-Flight Checklist; Starting/Stopping The Motors - dji MAVIC 2 ENTERPRISE Advanced User Manual

Hide thumbs Also See for MAVIC 2 ENTERPRISE Advanced:
Table of Contents

Advertisement

Pre-Flight Checklist

1. Make sure the remote controller, mobile device, and Intelligent Flight Battery are fully charged.
2. Make sure the Intelligent Flight Battery and the propellers are mounted securely.
3. Make sure the aircraft arms and propellers are unfolded.
4. Make sure the gimbal and camera are functioning normally.
5. Make sure that there is nothing obstructing the motors and that they are functioning normally.
6. Make sure that DJI Pilot is successfully connected to the aircraft.
7. Make sure all camera lenses and sensors are clean.
8. Make sure all accessories are correctly and securely mounted on the aircraft before use.
9. Use only genuine DJI parts or parts certified by DJI. Unauthorized parts or parts from non-DJI
certified manufacturers may cause system malfunctions and compromise safety.

Starting/Stopping the Motors

Starting the Motors
A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the inner or
outer bottom corners to start the motors. Once the motors have started spinning, release both sticks
simultaneously.
Stopping the Motors
There are two methods to stop the motors:
Method 1: when the aircraft has landed, push and hold the left control stick down. The motors stop
after three seconds.
Method 2: when the aircraft has landed, perform the same CSC that was used to start the motors as
described above. The motors stop immediately. Release both sticks once the motors have stopped.
Method 1
Stopping Motors Mid-Flight
Stopping the motors mid-flight will cause the aircraft to crash. The motors should only be stopped
mid-flight in an emergency situation such as if the aircraft is involved in a collision, a motor has stalled,
the aircraft is rolling in the air, or the aircraft is out of control and is ascending or descending very
quickly. To stop the motors mid-flight, perform the same CSC that was used to start the motors.
MAVIC 2 ENTERPRISE Advanced
OR
OR
Method 2
User Manual
©
2021 DJI All Rights Reserved.
57

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents