Mount Bottom Latch; Mount Top Latch - Assa Abloy Corbin Russwin ED8400 Series Installation Instructions Manual

ED8400 Series
Vertical Rod Exit Devices
Installation Instructions
3 Installation (cont .)
f

Mount Bottom Latch

Insert bottom latch screw through slot in latch frame
into bottom hole. Do not tighten. Lift up slide
assembly and fit the spring loop over the stump on
the latch frame. Position latch frame so that latch
engages strike. Now tighten bottom screw. Drill a
hole for the cover screw, using the hole in the slide
assembly at top as guide. Spot with 1/4" drill. Drill
through with #3 drill for self-tapping screw.
g

Mount Top Latch

Retract the latch by pushing up on slide and fasten latch assembly with screws as illustrated. Be sure to
draw the screw up tight. Drill hole for the cover screw, using the hole in the slide assembly at bottom as
guide.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2011, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Bottom Latch
Screw
Latch Screw
Door
Figure 12
9
Stump
Do Not Tighten Screw
Spring & Loop
Spring Over Stump
Tighten Screw
Bolt Engages Strike
Figure 11
FM22 06/19