Remove And Reinstall Cylinder In Knob - Assa Abloy Corbin Russwin ED8400 Series Installation Instructions Manual

ED8400 Series
Vertical Rod Exit Devices
Installation Instructions
4

Remove and Reinstall Cylinder In Knob

Remove Knob:
1. Insert key in cylinder and turn 90° clockwise.
2. Insert knob removing tool into the hole in the knob and depress the knob catch button.
3. While knob catch button is depressed, pull knob off.
Remove Cylinder From Knob:
1. Remove sleeve.
2. Remove key.
3. Slide cylinder out of knob.
(The knob catch button will
be in one of these positions.)
Here
Reinstall Cylinder in Knob:
1. Slide cylinder into knob.
2. Replace sleeve.
Reinstall Knob
1. With key inserted part way into cylinder slide knob onto knob shank.
2. Depress knob catch button and push knob onto the knob shank as far as it will go.
3. Insert key completely into the cylinder and turn key while pushing on the knob until it engages the
knob catch button.
4. Return key to its vertical position and remove it.
5. Pull on the knob to be certain it is properly engaged to the knob catch button.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2011, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Knob Catch Hole
Or Here
Removing
Tool
Key
Figure 18
13
Knob
Catch
Sleeve
Button
Cylinder
Knob
FM22 06/19