Figure 3-3 Location Of Serial Interface Connector - Emerson ATCA-F120 Installation And Use Manual

3.3.1 Connectors
The blade provides the following connectors at its face plate:
One serial interface
Ethernet management interface
AMC bay B1 Ethernet management interface
Ethernet Base Channel interface
3.3.1.1 Serial Interface
The serial interface connector allows to establish a serial console connection between the
ATCA-F120 and an external computer, for example a laptop. The serial interface is primarily
intended for management purposes and allows for example to access the blade's U-Boot
firmware (see
The following figure shows the location of the connector.
Figure 3-3
This interface is typically used to connect to and configure the U-Boot firmware. Refer to the
chapter "U-Boot Firmware" for further details.
ATCA-F120 Installation and Use (6806800D06F)
Chapter 5, U-Boot Firmware, on page
Location of Serial Interface Connector
Controls, LEDs and Connectors
101).
65