Emerson ATCA-F120 Installation And Use Manual page 42

Hardware Preparation and Installation
2.4 Installing Rear Transition Modules
As of writing this guide, the following rear transition module (RTM) were available: RTM-ATCA-
F120C and RTM-ATCA-F120-OPT
The RTMs are not hot-swappable. Before you install them, you must make sure that either no
front blade is installed in the respective slot, or that the front blade is powered-down. For
further details about the RTM installation refer to the Installation and Use guide of the
respective RTM.
2.5 Configuring the Blade
The blade provides the configuration switches SW1, SW2, SW3 and SW4. Their location is
shown in the following figure. The switch settings shown in the figure correspond to the
default settings. The switches are displayed as the small white squares.
42
ATCA-F120 Installation and Use (6806800D06F)