Table of Contents
Advertisement
3. Point to the corner in the bottom right of each Privacy area and drag the mouse to change the size. Then position the Privacy
area on the concerned area of the image.
4. Click on Save to activate the privacy area.
8.3.2
NETWORK
1)
Network configuration
Click on 【Network】→【Network Setting】 to access the following network page.
This page can be used to display and set the parameters related to the LAN of the camera:
➢
Type: DHCP, Static or PPoE. The default setting is Static.
➢
Command Port: This is the command port of the IP camera. Default: 6060
➢
HTTP Port: This is the web port of the IP camera. Defalut: 80
➢
IP address: Camera IP address
➢
Subnet Mask: Subnet mask of the IP camera.
➢
Gateway: IP address of the gateway used to access the Internet
➢
DNS1/DNS2: IP addresses of the DNS servers.
➢
Media Port: This is the client port of the IP camera. Default: 6066
➢
MAC address: This is the MAC address of the LAN board of the camera.
Only in the case that the camera has to be recorded by a network device HVR/NVR, it is advisable to set a static IP address
after having appropriately connected and configured the camera in the network. Make sure that the IP address you want to
assign to the camera is not already used in the network. It is better to use an address outside the range of addresses assigned
by means of DHCP.
Select "Type = Static" and fill in the following fields: IP address, Subnet mask, Gateway and DNS. Press Save to save the
changes.
2)
Video Stream
Click on 【Network】→【Video Streaming】 to access the following interface.
14
DS1099-077
Advertisement
Table of Contents
